Essence We.R Guide de l'utilisateur télécharger pdf (Page 112)

100

101

Installation of the WeR@Home™ System

112

WeR@Home

™

System User Guide

Figure 82: Dot Alignment of the Magnetic Sensor Units

3.8.2.2 Installing the Transmitter Unit with Screws

1. Release the Transmitter unit’s base by inserting a coin into one of the edge slots, as demonstrated in the

above Figure 80, and twist it to open the cover.

2. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 83 below).

Figure 83: Magnetic Sensor Transmitter Unit Base with Screws

3. Place and hold the base on the desired mounting location on the window/door frame and mark the

drilling locations (the above-mentioned punch-outs 1 and 2).

4. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the two (2) screws.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 290 291

Commentaires sur ces manuels

Pas de commentaire

Essence We.R Guide de l'utilisateur Page 112

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Essence We.R